There are several square holes
Posted: Thu Feb 13, 2025 5:18 am
Shredders are divided into drum and disc types depending on the structural shape of the working parts.
Crushers-shredders
Drum chippers are mainly used to cut branches, small diameter wood, board scraps, logs, etc. with a diameter or thickness less than 120mm. The cut wood sawdust is used as raw material for fiberboard and pulp.
The cutting mechanism is a rotating drum with several flying knives installed on it. When the flying knives rotate, the wood is processed into sawdust. on the outer edge of the drum, which allows the sawdust to come out smoothly. The feeding mechanism consists of a feeding interface, upper and lower feed rollers, and a feeding gap adjustment mechanism. The wood entering through the feeding interface is compressed by the upper and lower feed rollers and fed to the cutting mechanism colombia number data at a certain speed to control the size of the sawdust. When processing thick wood, the feeding gap adjustment mechanism is used for adjustment. After the sawdust has passed through the screen, the larger ones need to be crushed again between the blade and the fence.
Disc crusher
The disc crusher consists of cutting disc, cutting knife, lower knife, cutting disc blade, etc. There is a groove on the front of the cutting disc for installing the cutting blade, which is located at a radial angle of 10° to 15°.
At the bottom, the blade is laid with a wedge-shaped adjustment block for adjusting the blade protrusion. At the back, an adjustment seal is installed to adjust the compensation length of the blade after sharpening. There is a passage gap on the cutting disc along the blade direction, and the cut wood chips can be transferred to the other side of the cutting disc.
Crushers-shredders
Drum chippers are mainly used to cut branches, small diameter wood, board scraps, logs, etc. with a diameter or thickness less than 120mm. The cut wood sawdust is used as raw material for fiberboard and pulp.
The cutting mechanism is a rotating drum with several flying knives installed on it. When the flying knives rotate, the wood is processed into sawdust. on the outer edge of the drum, which allows the sawdust to come out smoothly. The feeding mechanism consists of a feeding interface, upper and lower feed rollers, and a feeding gap adjustment mechanism. The wood entering through the feeding interface is compressed by the upper and lower feed rollers and fed to the cutting mechanism colombia number data at a certain speed to control the size of the sawdust. When processing thick wood, the feeding gap adjustment mechanism is used for adjustment. After the sawdust has passed through the screen, the larger ones need to be crushed again between the blade and the fence.
Disc crusher
The disc crusher consists of cutting disc, cutting knife, lower knife, cutting disc blade, etc. There is a groove on the front of the cutting disc for installing the cutting blade, which is located at a radial angle of 10° to 15°.
At the bottom, the blade is laid with a wedge-shaped adjustment block for adjusting the blade protrusion. At the back, an adjustment seal is installed to adjust the compensation length of the blade after sharpening. There is a passage gap on the cutting disc along the blade direction, and the cut wood chips can be transferred to the other side of the cutting disc.